Hi Dojo,
I have a follow-up question related to this topic.
Changing the units on Spectrum Analyzer
As indicated in the answer, we can change the units in the View tab.
In our case, we plan to provision more than 50 spectrum elements. Is there a way to set the default unit in the connector?
Thanks.
Hello Miguel,
as discussed internally, a possible solution could be to make a shared preset with the desired unit and to set that preset on elements where you need the specified unit.
Kr.
Hi Miguel,
In the documentation of the reserved spectrum parameters, I found param 64008/64108, which sets the amplitude units. Unfortunately, I didn’t find any additional info on the usage of this parameter, but you can give this one a try.
64008 SPA_PARAM_AMP_UNITS Amplitude units (read)
64108 SPA_WPARAM_AMP_UNITS Amplitude units (write)
Hi Michiel,
Thanks for the information.
For your information, we found that the units selected can be stored in a preset.
This should be enough for our use case.
Hi Amar,
Indeed, presets are able to store the selected units.
Thanks!