Hi Everyone.
When using various Protocols on a daily basis, it is difficult to know when each parameter is being polled.
Some protocols have parameters that are not polled until one hour has passed since the last poll.
This is very inconvenient for operators who cannot see the Dataminer logs in detail.
Is it possible to list the polling cycle for each parameter ID somewhere?
Just stating the last polling time would be helpful.
*I understand that some very limited protocol parameters are made that way.
Of course I know that there is a Timebase.
But this value is only a relative multiplier and does not indicate the absolute value of time.
I would like the Dataminer software to record the polling time on the Dataminer software side, independent of the protocol.
It would be very easy to use if we could go one step further and modify the polling cycle for each specific parameter for each element above a certain authority.
Hi Yuki,
You can use the 'Last change' property that's available when you drill down to one parameter in specific (double-click in the parameter).
This will show you the last time this parameter was updated, which should match with the last time it was polled.
Yes, if there is a Last Polling:dd-mm-yy here, my hope will be fulfilled.
Bruno – I believe this indicates when the value of the parameter changed for the last time, not when it was polled (if a poll occurs, and the value of the parameter is the same as when it was polled previously, then this time stamp is not updated)