Hello,

I need some advice on Active alarms tab. I have an AppearTV XC5100 chassis with some modules. The AppearTV drivers are loaded up and the Alarm template is defined per module.

I checked all the alarms related to my input module and i have attached the template to the module. At this moment i can see a green dot on my module. This means that there are no actual alarms.

In order to test the alarms, i have created an Input without any content inside. XC5100 chassis is now reporting me a critical alarms with no input. If i go to my view -> XC5100 ip input card -> Alarms section on Dataminer Cube, i can see the alarm listed there.

But there is no alarm on the Active alarms listed on the bottom of the Dataminer Cube app window.

I am still looking into documentation but any advice is welcomed so i can speed up my installation.

The main question for this situation is: How can i be sure that Dataminer will display any alarm that could occur on my device?

Thank you!

Marian