Hello everyone,
On the DMA, if we go on the Services page, under the definitions we have the list of all functions as shown on the picture down below.
We have two functions for Signal Quality Verification. However, for the Evertz Vistalink connector, the function doesn't group with the one for the Snell.
I've checked and the ids match.
Any idea why is not linking?
Thank you
Hi Ana,
This would typically happen if the interfaces on your protocol-specific function don't match with the interfaces of your parent system function.
Can you double-check if the name, type, and profile are the same for all interfaces in your function definition?
Also each of the interfaces within the child function needs to have the same id (guid) as its counterpart in the parent function.
Can you verify if this is the case?
Hello Ruben,
As I said on Ive’s comment, I’ve check everything and the only difference was on interfaces id.
Thank you for the support.
Hello Ive,
I’ve check everything and the only difference was on interfaces id that were not matching. I changed them and it’s working.
Thank you for the support.