Hello,
we have two network ports configured on DMA. Alarms sent out of SNMP manager used to use the first one. After restart of the DMA now the manager uses the second one. Can I force it to use only one port permanently? Its causing problems on the destination side.
Thanks,
M.
Marieke Goethals [SLC] [DevOps Catalyst] Selected answer as best 21st November 2024
As this question has now been inactive for a very long time, I will close it. If you still want more information about this, could you post a new question?
Hi Martin,
If it is intended to have just one network card port in use, would it be possible to configure only one IP address in the DMA VM?
Could you please provide additional information regarding the current SNMP Manager setup to facilitate the troubleshoot?
Marieke Goethals [SLC] [DevOps Catalyst] Selected answer as best 21st November 2024
Hi,
I see that this question has been inactive for some time. Do you still need help with this? If not, could you select the answer that has been most helpful for you (using the ✓ icon)?