Function definition not recognizing parent id

Solved687 viewsFunction Definition SRM
2
0 Comments

Hello everyone,

On the DMA, if we go on the Services page, under the definitions we have the list of all functions as shown on the picture down below.
We have two functions for Signal Quality Verification. However, for the Evertz Vistalink connector, the function doesn't group with the one for the Snell.

I've checked and the ids match.

Any idea why is not linking?

Thank you

Ana Pinho [SLC] [DevOps Advocate] Selected answer as best 22nd March 2022

2 Answers

2
12.18K 1 Comment

Hi Ana,

This would typically happen if the interfaces on your protocol-specific function don't match with the interfaces of your parent system function.

Can you double-check if the name, type, and profile are the same for all interfaces in your function definition?

Ana Pinho [SLC] [DevOps Advocate] Selected answer as best 22nd March 2022
Ana Pinho [SLC] [DevOps Advocate] commented

Hello Ive,

I’ve check everything and the only difference was on interfaces id that were not matching. I changed them and it’s working.

Thank you for the support.
You are viewing 1 out of 2 answers, click here to view all answers.