Hi Dojo Community,
I'm currently having issues trying to receive some traps in a custom connector.
I have setup the trap receiving parameter as this
And I'm sending the traps via TrapSender of the QADeviceSimulator Tool from another server
I verified the IP and the Port to match the DMA ID, and the port set up on the element.
On wireshark I can see traffic and the trap traffic appears correctly, however, the element does nothing. I have a QAction triggered on the trap receiver parameter and I put a log right at the start to verify is going into the QAction, however nothing happens.
Is there something that I'm missing on the configuration either sending or receiving the trap?
Luis while I might not have a direct answer to the problem you are facing, I can provide a way to test with some connectors available in the catalog today. You could use these to validate or compare the trap syntax and format against your test case.
Generic Trap Receiver
https://catalog.dataminer.services/details/83fb1a4c-063c-4fa0-ad0a-d23e1f1510c3
Generic Trap Simulator
https://catalog.dataminer.services/details/93297b7c-dbac-472d-9337-1d9099f97d02
I will not be investigating this issue anymore as I changed focus and this no longer is a priority
Hi Luis,
Can you enable ‘Log everything’ in the SLSNMPManager log file and confirm that the trap OID is available in the log file?
Can you double check in the wireshark capture if the trap OID matches the wildcard defined in the parameter?