Dear community,
I have a question related to the layout of a matrix component in a connector. I was able to successfully change the default layout from a default 16x16 to a layout that matches the dimensions of the matrix card of this particular deployment (Evertz EQX with IP18AD - 18 x 18) by importing a custom csv file. See below.
The matrix editor in the alarm template however still shows the default layout. Is there a way to make this consistent such that the matrix alarm level editor show the same dimensions and layout as the component in the connector itself (in this case 18x18)?
Or is this a limitation in the software?
Hi Koen,
This is a software limitation, in the alarmtemplate editor, we always use the default page size.
However, if the connector would use a Table-based matrix, the alarming is used on the tables.
Where the current Standard matrix still relies on the matrix alarmtemplate.
Example of Table-based matrix:
I hope this was enough information.
Kind Regards,
Robbe