Dear community,
I have a question related to the layout of a matrix component in a connector. I was able to successfully change the default layout from a default 16×16 to a layout that matches the dimensions of the matrix card of this particular deployment (Evertz EQX with IP18AD – 18 x 18) by importing a custom csv file. See below.
The matrix editor in the alarm template however still shows the default layout. Is there a way to make this consistent such that the matrix alarm level editor show the same dimensions and layout as the component in the connector itself (in this case 18×18)?
Or is this a limitation in the software?
Hi Koen,
This is a software limitation, in the alarmtemplate editor, we always use the default page size.
However, if the connector would use a Table-based matrix, the alarming is used on the tables.
Where the current Standard matrix still relies on the matrix alarmtemplate.
Example of Table-based matrix:
I hope this was enough information.
Kind Regards,
Robbe