Hello @ here,
Would anyone know if it would be possible to clear a "Critical HI" alarm if the condition remains for 30 mins. I am using Arista Manager protocol and configuring Operation State and I want to know when an interface goes down however, there are several ports disconnected so the Alarm Template sees that as a Critical high as configured. I need to figure out how to clear down ports if they are down for more than 30. This is assuming the port is down or disconnected by an administrator which shouldn't be flagged as a Critical High 
Pieter Van Compernolle [SLC] [DevOps Enabler] Selected answer as best 25th February 2025
Hi Juan,
I would try the following solution if I understood the problem correct:
This way it should go off after 30mins. We don't alarm on Admin State only on Oper. State. I hope it helps.
Pieter Van Compernolle [SLC] [DevOps Enabler] Posted new comment 24th February 2025
This is hysteresis you are trying to apply. Not sure if this will solve the problem mentioned here. Hysteresis will delay the alarm or the clearance of the alarm. Here we want to get the alarm immediately, but want it cleared after 30.