Answer
22nd December 2020
The acquisition network is typically used by DataMiner to synchronize its files with the passive agent, while the corporate network can be used for detection of automatic switching purposes (typically …
22nd December 2020
Hello Jeff, Some of these questions we had already discussed during our previous call, but I will answer them here as well to document them for future reference. 1: Currently, …
22nd December 2020
Hi Paul, You can achieve this using correlation. Below you’ll find a sample configuration.
22nd December 2020
The Logging\WatchDog\Reports and Logging\WatchDog\Notifications folders are currently limited to storing 90 days of entries (30 days before 9.6 CU12/10.0 CU1). There are currently no options available to override this. There’s …
22nd December 2020
Hi Bruno, When a Failover switch is triggered, it will go through 4 steps: Stop the DataMiner software Release the VIP IP (or the first steps are covered by the …
22nd December 2020
Hi Jeff, There’s no way to prevent specific information events from being generated. The information events from the screenshot are most likely generated when the configuration of DataMiner services gets …
22nd December 2020
Hi Jeroen, can you try adding user credentials to the URL like below? It’s recommended to set up a dedicated user with very limited rights for this. http://user:pass@<DMAIP>/VideoThumbnails/…
22nd December 2020
1. The online DMA (primary DMA) will stop polling the elements, and the offline DMA (backup DMA) will begin polling of the elements. Also the virtual IP will be removed …
21st December 2020
Hi Gabriel, Let me please point you to: Protocol development checklists – DataMiner Dojo In the checklist you will find the applicable guidelines on the allowed ID Range, ID Gaps, …
21st December 2020
The entire flow, from “set on the UI” until we can confirm the set in the UI has quite a few steps, and is probably a topic for an article …
21st December 2020
Corporate typically refers to the NIC/VLAN used to interface with the network where the users of the system reside (i.e. the office network) and Acquisition typically refers to the NIC/VLAN …
21st December 2020
I’m assuming that you are referring to re-applying a service template for an already created service. While re-applying, all placeholders indeed get re-evaluated. There is no option to skip some. …
21st December 2020
The only way in which DataMiner uses WinPcap is to inject Gratuitous ARP packages directly on the network when a Failover switch is done. This sends out an extra announcement …
21st December 2020
Definitely also check this dojo post.
21st December 2020
Yes, if the table cell is not initialized then the returned object is null (tested on DataMiner 10.0.12.0)
