Learning

Hi David, For this case you could use regular expressions. In the example below, I will include all elements that contains the name ‘TEST_ELEMENT’: It is true that for this …

Hi Andre, Thanks for your question. We do have plans in place to transition from WMI to WinRM. At this moment, our primary focus is on integrating the two main …

Hi Adrian, The option to change the preferred source for the redundancy settings has been added in a later version. I notice you are currently running version 1.2.4.23 where this …

This can be done using the correlation module. You can create a correlation rule and set a rule condition ‘alarm type not equal to Acknowledged’ and set the rule to …

Hi Yvan, I had some issues with the aggregator recently and AFAIK, you indeed need to be connected to dataminer.services to make the installation. The prerequisites in the documentation indeed …

Hi Mieke normally these are documented here: Running BPA tests | DataMiner Docs. Note that CompareFiles is not in there (hence your question probably). I looked around and could not …

Hi Pawel, I’ve checked with our experts, and it appears that this problem is too complex to be able to tackle it here in the Q&A. Could you contact techsupport@skyline.be …

Hi Martin, If it is intended to have just one network card port in use, would it be possible to configure only one IP address in the DMA VM? Could …

Hi this should be possible by unchecking the checkbox next to “Local Paths” and only leaving the one for “Store the backups on a network path” enabled.

Hey, DirectConnection has a hard dependency on ElasticSearch/OpenSearch. So your element will throw errors if that’s not available. Regards

Hi Simon, This is the standard way of showing a comment in the alarmconsole. Unfortunately it is currently not possible to trim the first part.

Hi Michael, It should be possible to automatically generate parameter xml and insert it in an existing protocol xml. However, you’ll then just end up with empty parameters and I …